Skip to main content

Ordering guide

How to count screws and closures for a metal roof

Running short of screws or closures stops a crew cold. This guide shows how to turn the fastening pattern on your drawings into a count. It does not tell you what the pattern should be: screw type, spacing and pattern come from your building's engineering documents and the panel instructions.

Updated October 1, 2026

Start with the pattern on your drawings

Your drawings or panel instructions show how many screws go across each sheet where it crosses a purlin, and where the side laps and trim are fastened. Have that page in front of you before you count.

Count the panel screws

Multiply three numbers: the screws across one sheet at one purlin, the number of sheets, and the number of purlin lines the sheets cross. Do it for each roof side and add them up.

The arithmetic, with letters instead of numbers: S screws across a sheet, N sheets per side and P purlin lines is S x N x P screws per side. Take S and P from your building's drawings and the panel maker's fastening sheet; we do not set the pattern.

Count the stitch screws

Stitch screws fasten steel to steel: along each side lap between sheets, and through the trim. Count the side laps (one fewer than the number of sheets on each side), multiply by the stitch screws your drawings show per lap, and add the trim fasteners the same way.

Count the foam closures

  • Inside closures sit under the panels at the eave: one per sheet along each eave.
  • Outside closures sit on top of the panels under the ridge cap: one per sheet on each side of the ridge.
  • Add closures at any other place a panel end meets a trim, such as a high wall over a low roof.

Count the butyl tape

Add up the length of every run that gets tape: along the eave and ridge closures and across each end lap. Divide by the length of one roll and round up.

Allow for the job site

Screws get dropped and closures get torn. Check your drawings and allow for job-site loss. Order screws by head color to match each panel color, plus a bag of unpainted screws for hidden spots.

Your building's engineering documents govern sizes, gauges, spacing and connections. We supply parts to match them; we do not give engineering advice.

Questions

What length screw do I need?
It depends on what the screw passes through. Your drawings or panel instructions list it. Longer screws are for blanket insulation, a thermal block or a second layer of steel.
What is the difference between an inside and an outside closure?
An inside closure fills the ribs under the panel, at the eave. An outside closure fills the ribs on top of the panel, under a trim such as the ridge cap.
Do I need closures if I have trim?
Yes. Trim covers the edge, but the ribs leave gaps under it. Closures fill those gaps against wind-driven rain, birds and insects.
Can you count the screws for me?
Count them from your building drawings. The fastening pattern always comes from your engineering documents. If you are unsure, use the contact form before you order.
Cart (0)